How to Use the Webasto Gas Heater in Your MoveMobility Vehicle

A quick orientation to the Webasto gas heater in your MoveMobility vehicle: how to use the SmarTemp control to set the temperature, switch between heat and vent, run it on a timer and keep it safe.

This short orientation walks through the Webasto SmarTemp control that runs the gas heater in your vehicle. It has two buttons, the Webasto button on top and the SmarTemp button on the bottom, plus a dial.

Key Points

• Press the Webasto button to see the current temperature inside the vehicle. The last temperature you set shows in the bottom left.
• Turn the dial clockwise to raise the temperature and counterclockwise to lower it, then press the Webasto button to turn the heater on. Red lights mean it’s heating.
• Press the SmarTemp button to open the menu, and use Mode to switch between heat and vent. Blue lights mean vent only, with no heat.
• Use Timer in the menu to run the heater on a schedule. Before parking in a garage or refuelling, set it back to manual and turn it off so it can’t start on its own.
• The heater draws fuel from your vehicle’s tank two-thirds of the way down, so a third of a tank is always left to get you where you’re going.

Questions about your heater? Our service team can walk you through it.